User's Manual
43
FUNCTION MENU SETUP
2. Press / key to choose NO. 28 function item, it shows “ID” on LCD.
3. Rotate channel switch to choose desired setup.
The ID code displaying on LCD is transceiver self ID code.
4. Press
key or key to conrm and exit.
NOTE: When current channel add 5TONE to be optional signaling, LCD displays 5TONE self ID code,
otherwise displays DTMF self ID code.
Tone Pulse Frequency Selection
This function is used for waking up sleeping repeater, it needs a certain intensity of Tone Pulse to wake up
sleeping repeater. In general, as long as the repeater has been waked up, no need to transmit Tone Pulse
again in preset time.
1. Press
key, the top left corner of LCD displays “ ” icon, then press
key enter into function menu.
2. Press
/ key to choose NO. 29 function item, it shows “TBST” on LCD.
3. Rotate channel switch to choose desired setup.
1750HZ, 2100HZ, 1450HZ, 1000HZ, 4 kinds of Tone Pulse for optional
4. Press key or key to conrm and exit.
Battery Save Setup
User can setup battery save ratio according to requirements. The standby time can be extended when
enable battery save function, but if save ratio setting too high, it may cause voice missing.