Installation guide

5 – Diagnostics and Troubleshooting
Power-On Self-Test Diagnostics
5-2 SN0051102-00 A
S
Input Power LED is Off
The input power LED lights up to show that the router logic circuitry is receiving
proper voltages. If the input power LED is off, do the following:
 Inspect power cord and connectors. Is the cord unplugged? Is the cord or
connector damaged?
 Yes – Make necessary corrections or repairs. If the condition remains,
continue.
 No – Continue.
 Inspect AC power source. Is the power source delivering the proper voltage?
 Yes – Continue.
 No – Make the necessary repairs. If the condition remains, continue.
 Replace the router.
System Fault LED is On
The system fault LED will blink a specific pattern to indicate the problem. If the system
fault LED lights up, take necessary actions (see page 5-3).
Power-On Self-Test Diagnostics
The router performs a series of tests as part of its power-on procedure. The POST
diagnostic program performs the following tests:
 Memory
 FLASH validation
 PCI device discovery
 Management Ethernet port