User`s guide

A – Log Messages
Fatal Log Messages
A-28 SN0054660-00 A
S
FC Driver
The following fatal log messages are common to both Fibre Channel ports, 1
(FC1) and 2 (FC2). They are listed in Table A-14 and described following the
table. Log messages beginning with #0 denote Fibre Channel port 1 (FC1). Log
messages beginning with #1 denote Fibre Channel port 2 (FC2).
978 iSCSI processor reboot failed.
1152 iSCSI processor NVRAM invalid (checksum error).
1203 iSCSI FLASH (NVRAM) command failed.
1204 iSCSI firmware loader invalid state.
1205 iSCSI failed to load firmware in time allotted.
Table A-14. Fibre Channel Driver—Fatal Log Messages
ID Log Message No.
102419 #%d: qlutm_init: Diagnostic failed, port 1 invalid SRAM 19
102420 #%d: qlutm_init: Diagnostic failed, port 1 POST failed 20
102421 #%d: qlutm_init: Diagnostic failed, port 2 invalid SRAM 21
102422 #%d: qlutm_init: Diagnostic failed, port 2 POST failed 22
102423 #%d: qlutm_init: Failed to return diagnostic result to Bridge 23
102656 #%d: QLInitializeAdapter: Reset ISP failed 256
102657 #%d: QLInitializeAdapter: Load RISC code failed 257
102658 #%d: QLInitializeAdapter: Load ISP2322 receive sequencer code
failed
258
102659 #%d: QLInitializeAdapter: Load ISP2322 transmit sequencer
code failed
259
102662 #%d: QLInitializeAdapter: Verify Checksum command failed (%x) 262
102680 #%d: QLInitializeFW: FAILED 280
102688 #%d: QLInterruptServiceRoutine: Risc pause %x with parity error
hccr %x, Disable adapter
288
102689 #%d: QLInterruptServiceRoutine: Invalid interrupt status: %x 289
10691 #%d: QLFcipInterruptServiceRoutine: Risc pause %x with parity
error hccr %x, Disable adapter
291