Installation guide

C–Log Messages
ISR651101-00 H C-17
86347 #%d: QLDisable: Restart RISC iSCSI Info Restart iSCSI processor (RISC).
86349 #%d: QLEnable: Restart RISC to update
EEPROM
iSCSI Info EEPROM updated, restart iSCSI processor (RISC).
86874 #%d: QLIsrDecodeMailbox: Link up iSCSI Info Link up reported by iSCSI processor for GE1 or GE2.
87346 #%d: QLGetFwStateCallback: link 100Mb FDX iSCSI Info The iSCSI controller reported a link speed or configu-
ration of 100Mb full-duplex (FDX).
87348 #%d: QLGetFwStateCallback: link 1000Mb
FDX
iSCSI Info The iSCSI controller reported a link speed/configura-
tion of 1000Mb FDX.
87350 #%d: QLGetFwStateCallback: Invalid link
speed 0x%x
iSCSI Info The iSCSI controller reported an invalid link speed.
102419 #%d: qlutm_init: Diagnostic failed, port 1
invalid SRAM
FC Fatal FC1 processor SRAM test failed.
102420 #%d: qlutm_init: Diagnostic failed, port 1
POST failed
FC Fatal FC1 processor power-on self-test (POST) failed.
102421 #%d: qlutm_init: Diagnostic failed, port 2
invalid SRAM
FC Fatal FC2 processor SRAM test failed.
102422 #%d: qlutm_init: Diagnostic failed, port 2
POST failed
FC Fatal FC2 processor POST failed.
102423 #%d: qlutm_init: Failed to return
diagnostic result to Bridge
FC Fatal Fibre Channel processor failed to return diagnostic
results.
102656 #%d: QLInitializeAdapter: Reset ISP
failed
FC Fatal Fibre Channel processor failed reset.
Table C-1. iSR6200 Router Log Messages (Continued)
ID Log Message
Module
Type
Msg.
Type
Description