Installation guide

3–Installation
Installing the iSR6200 Router
ISR651101-00 H 3-3
5. Connect the management workstation to the router (see page 3-8).
6. Configure the management workstation (see page 3-9).
7. Install the management utility (see page 3-11).
8. Start the management utility (see page 3-14).
9. Configure the router (see page 3-14).
10. Cable devices to the router (Fibre Channel and iSCSI) (see page 3-15).
Pre-installation Check List
During the initial configuration process, the system prompts you to enter
information for each blade contained in the iSR6200 chassis. Use the space
provided in the following tables to record the IP addresses for each blade.
Table 3-2. Worksheet for Router Blade 1 (left) Parameters
Symbolic Name of the iSR6200
Blade 1
Management port IP address,
subnet mask, and gateway (if not
using DHCP)
iSCSI port 1 IP address, subnet
mask, and gateway (GE-1)
IP address of the iSNS server for
iSCSI port 1 (if iSNS will be
enabled)
iSCSI port 2 IP address, subnet
mask, and gateway (GE-2)
IP address of the iSNS server for
iSCSI port 2 (if iSNS will be
enabled)
iSCSI port 3 IP address, subnet
mask, and gateway for the
optional (FC3, GE-3, or 10GE-3)
port
IP address of the iSNS server for
iSCSI port 3 (if iSNS will be
enabled)