User`s guide

SN0054667-00 C 1-1
1 System Requirements
QConvergeConsole CLI is an management utility that centralizes management
and configuration of QLogic adapters within the entire network (LAN and SAN).
For optimum performance, QConvergeConsole CLI requires the hardware,
software, and operating systems listed in this chapter:
 Hardware Requirements
 Software Requirements
 Operating System Requirements
 Supported QLogic Adapters
Hardware Requirements
The minimum hardware requirements for the workstation server are as follows:
 Server.
Single-processor or multiprocessor server or workstation. See
“Operating System Requirements” on page 1-2 for a list of operating
systems.
 Processor. Pentium
®
II processor, 300 MHz
 Memory. 64MB of physical RAM to run QConvergeConsole CLI
 Hard disk space. About 26MB disk space.
The minimum hardware requirements for the adapter are as follows:
 Adapters. One or more of the QLogic adapters listed under “Supported
QLogic Adapters” on page 1-2.
The minimum requirements for a SAN environment are as follows:
 Storage. Fibre Channel or iSCSI devices, such as disks and RAID
subsystems. QConvergeConsole CLI supports most Fibre Channel and
iSCSI devices. See the QLogic Storage Networking Interoperability Guide,
which you can download from the following QLogic Web page:
http://connect.qlogic.com/interopguide/info.asp