User`s guide

2 – QLA2310F/2310FL

Installation in the Computer

2-4 FC2354603-00 A

7. Secure the QLA2310F/2310FL HBA to the chassis. Follow the PC

manufacturer’s instructions.

8. Connect the appropriate cable from the devices to the corresponding connector.

9. Carefully reinstall the computer cover. Insert and tighten the computer cover

screws.

10. Power up all external FC devices, then power up the PC and observe the

monitor. The BIOS is disabled by default. Consequently, the devices attached

to the QLA2310F/2310FL HBA are not identified. For example:

QLogic Corporation

QLA23xx PCI Fibre Channel ROM BIOS Version x.xx

www.qlogic.com

Press <CNTRL-Q> for Fast!UTIL

BIOS for Adapter 0 is disabled

ROM BIOS not installed

NOTE:

■ SunSPARC systems do not display the BIOS banner.

■ Enable the BIOS only if the boot device is attached to the

QLA2310F/2310FL HBA. This allows the system to boot faster.

■ For further information about enabling the QLA2310F/2310FL HBA

BIOS, see the appropriate readme.txt.

If the information displayed on your monitor is correct, congratulations! You have

successfully installed the QLA2310F/2310FL HBA in your computer.

If the information displayed is not correct and you have checked the

QLA2310F/2310FL HBA’s configuration, see section 3 for troubleshooting

information.

See the associated readme.txt file for detailed instructions on how to install the

software drivers.

If you need FCode (Solaris SPARC systems), see the associated readme.txt file for

instructions on how to install or update the FCode on the QLA2310/2310FL HBA.

Optionally, you can customize the QLA2310F/2310FL HBA and its attached devices

using the Fast!UTIL BIOS utility. See the associated readme.txt file for detailed

instructions.