User`s guide

2 – QLA2310F/2310FL

Specifications

FC2354603-00 A 2-5

2.2.1

Installation Help

If your system has an IDE hard disk, it may be assigned device number 80, which

is the boot device. If your system does not have an IDE hard disk, a parallel SCSI

host bus adapter (HBA), or a RAID adapter, the first bootable FC hard disk

configured (the one with the lowest ID) is assigned device number 80 and becomes

the boot device. The QLA2310F/2310FL HBA BIOS must be enabled if the boot

device is connected to the QLA2310F/2310FL HBA.

If you have a selectable boot BIOS and want to boot to an FC hard disk, set the

motherboard BIOS parameters to None or Not Installed. The ROM BIOS on the

QLA2310F/2310FL HBA automatically configures the FC peripherals.

Some new system BIOSs support selectable boot, which supersedes the

QLA2310F/2310FL HBA BIOS selectable boot setting. Select the

QLA2310F/2310FL HBA FC hard disk in the system BIOS to boot from an FC hard

disk attached to the QLA2310F/2310FL HBA.

2.3

Specifications

Tables 2-1 and 2-2 define the QLA2310F/2310FL specifications.

Table 2-1. QLA2310F/2310FL Board Operating Environment

Environment Minimum Maximum

Operating temperature 0°C/32°F 55°C/131°F

Storage temperature –20°C/–4°F 70°C/158°F

Relative humidity (noncondensing) 10% 90%

Storage humidity (noncondensing) 5% 95%

Table 2-2. QLA2310F/2310FL Board Specifications

Type Specification

Host bus Conforms to PCI Local Bus Specification, revision 2.2 and the

PCI-X Addendum, revision 1.0

PCI/PCI-X signaling

environment

3.3 V and 5.0 V buses supported

PCI/PCI-X transfer

rate

132 MBps maximum burst rate for 32-bit PCI operation at 33 MHz

264 MBps maximum burst rate for 32-bit PCI/PCI-X operation at

66 MHz

264 MBps maximum burst rate for 64-bit PCI operation at 33 MHz

528 MBps maximum burst rate for 64-bit PCI/PCI-X operation at

66 MHz