Installation guide

1–Installation
12200/12300 Installation
D000102-000 B 1-9
Figure 1-6 Insert Management Module 4
Four Post Standard-Depth Rack Installation
In a standard-depth rack, the distance between the front and back mounting posts
is ~28" (700mm). Mounting rails for the 12200 and 12300 are adjustable to
accommodate racks with 26"-33" between mounting posts.
Mounting Hardware Kit Contents:
• One pair of mounting rails adjustable for 26"-33" installation range
• One pair of hat rails, left and right
• #6-32 screws
• M6 cage nuts
•M6 screws
Installation
1. Install the hat rails on each side of the switch using three (3) #6-32 screws per
rail. Torque screws to 8in-lb. A typical installation is shown in Figure 1-7. On
the 12300, hat rails are installed with mounting ears towards the power supply