Installation guide

1–Installation
12800-120 Installation
1-16 D000140-001 D
12800-120 Installation
Mounting Hardware Kit Contents:
 Support Rails
 HAT Brackets
 C-Brackets
 #8-32 Flat Head Screws
 M6 Mounting Screws
 M6 Clip Nuts
Installation Tasks
1. If applicable, remove the doors of the rack.
2. Install the clip nuts Install M6 clip nuts in the following locations on EIA rails:
NOTE:
The mounting kit contains all of the necessary parts for installing and
mounting the switch into a 19" 4-post server rack, with a distance between
front and rear rack posts ranging from 28" - 33" (711mm - 838mm).
NOTE:
The mounting kit contains all of the necessary parts for installing and
mounting the switch into a 19" 4-post server rack, with a distance between
front and rear rack posts ranging from 28" - 33" (711mm - 838mm).