User`s manual
Table Of Contents
- Preface
- General Description
- Installation
- Introduction
- Unpack
- Place or Mount the Equipment
- Apply the IEC Class 1 Laser Information Label (If the installation is in Europe)
- Install GBICs
- Connect to AC Power
- Switch Logic Power Good LED
- Check the Power-On-Self-Test (POST) Results
- Cable Fibre Channel Devices to the Switch
- Configure the Chassis
- Configure the Ports
- Zoning
- Rack and Shelf Administration
- Operating the Switch
- Diagnostics/Troubleshooting
- Removal/Replacement Procedures
- Multi-Chassis Fabrics
- Reference Information
- QLogic Customer Support
- Index
Preliminary
SANbox-16HA Fibre Channel Switch
Installer’s/User’s Manual 59005-03 Rev. A Reference Information A-1
Appendix A Reference Information
Appendix A contains the specifications for the SANbox-16 Fibre Channel Switch.
Refer to “Fibre Channel Ports” on page 1-17 for the location of all connections,
switches, and components.
QLogic Customer Support
Phone: ................................................(952) 932-4040
Fax:.....................................................(952) 932-4018 Attn: Customer Support
E mail:................................................support@QLogic.com
Web: ...................................................www.QLogic.com
Please refer to Appendix B QLogic Customer Support for an explanation of
QLogic Customer Support.