User`s guide

4–Non-Interactive Commands

Command Summary

SN0054614-00 K 4-7

To view the adapter port’s LED beacon state, type:

# scli -a (<hba instance> | <hba wwpn>)(view | ?)

When the adapter’s LED is flashing, the following message appears:

HBA Port x - LED Flashing is ON.

When the adapter’s LED is not flashing, the following message appears:

HBA Port x - LED Flashing is OFF.

In Solaris SPARC, include double quotes around the question mark (?) if the

system is running with a csh or tsch shell. For example:

# scli -a <hba> "?"

To start or stop flashing the adapter’s LED beacon, type:

# scli -a (<hba instance> | <hba wwpn>)

SANsurfer FC/CNA HBA CLI toggles the LED’s state. If the LED is flashing, the

flashing stops. If the LED is not flashing, the flashing begins.

If SANsurfer FC/CNA HBA CLI is not in silent mode (see “-s (Silent Mode)” on

page 4-45), one of the following messages appears to indicate the LED’s current

state:

The LED Flashing for <hba instance> <hba wwpn> has been turned

OFF

The hba instance and hba wwpn variables must match the command input

parameter.

-b

(Save or Update the Flash BIOS or FCode)

Use the -b command to:

 Update the BIOS or FCode from a file (1).

 Save the BIOS or FCode to a file (2).

NOTE:

 Adapter must not be in silent mode. See “-s (Silent Mode)” on page 4-45

to issue a response to this command.

 The -a feature is not supported on QLA22xx adapters or QLE8042

adapter.