User`s guide

11 – Updating the HBA
Updating the HBA Port Settings, Advanced HBA Port Settings, and Boot Device
11-12 FS0054603-00 C
Q
■ Enable Target Reset. This setting enables the drivers to issue a Target Reset
command to all devices on the loop when a SCSI Bus Reset command is issued.
The default is disabled.
■ Fast Error Reporting (Solaris SPARC). This setting instructs the driver to
remove the delay between I/O command errors sent during a loop down
condition. The default is disabled.
■ Link Down Error (Solaris SPARC). This setting enables/disables error reporting
to the operating system during a loop down condition. If this setting is disabled
during a loop down condition, the driver holds the I/O commands until the loop
is back up, then re-issues the commands. The default is enabled.
■ LUNs per Target. This setting specifies the number of LUNs per target. Multiple
LUN support is typically for RAID boxes that use LUNs to map drives. The default
is 8. If you do not need multiple LUN support, set the number of LUNs to 0.
11.1.3
Boot Device Selection
NOTE: This option cannot be set for multiple HBA ports (only the HBA Port
Settings and Advanced HBA Port Settings options apply to multiple HBA
ports).
To view or select a target device as a boot device for an HBA port, on the Settings
tabbed page Select Settings section box, select Boot Device Selection. The Boot
Device Selection section displays the current settings (see figure 11-7).
Figure 11-7. Settings Tabbed Page (Boot Device Selection)