Installation guide

Installing and configuring the QLogic QLA40xx and QLe40xx iSCSI adapter (TOE)
139
Miscellaneous Planning and Procedures
◆ From the HBA Options, you can set the iSCSI HBA parameters
including IP address, subnet mask, and gateway. If an iSNS server
is being used for your iSCSI configuration follow the procedure
for setting up iSNS later in “Configuring iSNS settings for
QLA4010” on page 140.
Figure 115 SANsurfer iSCSI HBA Manager, HBA Options
Important notes For Microsoft support on Windows 2003 operating systems, it is
required that the latest version of Microsoft Initiator SERVICE be
installed. Installing the entire Initiator package may cause a conflict
with the QLogic iSCSI HBA functionality. After installing the Initiator
service, it will change the QLogic iqn to the Microsoft iqn naming
convention (for example,
iqn.1991-05.com.microsoft:username.domainname).