Installation guide

Installing and configuring the QLogic QLA40xx and QLe40xx iSCSI adapter (TOE)
141
Miscellaneous Planning and Procedures
Configuring iSNS settings for QLA4010
For iSNS support, the QLA4010 must be running the correct driver.
Refer to the for latest version.
Targets must register with the iSNS server. To register, enable the
iSNS server and enter the IP address using the SANsurfer iSCSI
HBA Manager, HBA Options, Network, Enable iSNS dialog box.
Click Save HBA under the Network tab on the SANsurfer iSCSI
HBA Manager, HBA Options tab.
The target should be detected by SANsurfer and shown on the
SANsurfer iSCSI HBA Manager, Target Settings tab. Click Save
Settings to bind the targets.
If the targets are not detected, follow these steps:
1. Ping successfully to the iSNS server using the Diagnostics tab
from the SANsurfer iSCSI HBA Manager dialog.
2. Go to iSNS server and iSNS server icon in the control panel or
desktop.
3. Open Discovery Domain and confirm that both the QLA4010
and target ports are registered with the domain.