Installation guide

144
EMC Host Connectivity with QLogic Fibre Channel HBAs and CNAs in the Windows Environment
Miscellaneous Planning and Procedures
◆ To configure your iSCSI targets, click the Target Settings tab from
the SANsurfer iSCSI HBA Manager dialog, as shown in
Figure 119.
Figure 119 SANsurfer iSCSI HBA Manager, Target Settings tab
◆ To add your target, click the green + on the right side of the Ta rg et
Settings tab to get the IP Address dialog, as shown in Figure 120.
Enter the IP address of your target port, and click OK.
Figure 120 SANsurfer iSCSI HBA Manager, Target Settings, IP Address dialog