Installation guide

32
EMC Host Connectivity with QLogic Fibre Channel HBAs and CNAs in the Windows Environment
Installation and Configuration
6. From the Configuration Settings dialog, select Selectable Boot
Settings and press Enter.
Figure 11 Selectable Boot Settings window
7. Selectable Boot is Disabled by default. Select this setting and
press Enter to enable Selectable Boot.
8. Scroll down to the (Primary) Boot Port Name, LUN: setting, and
press Enter.
The Fast!UTIL will now scan for attached FC devices (as shown
in Figure 12 on page 33). If physical connectivity to the array is
setup properly via zoning, then the array port will be found after
this scan. Use the <PageUp> and <PageDown> keys to navigate
the list of target IDs for the array port being used for boot.