Installation guide

Booting from the external storage array
39
Installation and Configuration
Table 4 lists the pre-configured parameters for 8 Gb/s and 16 Gb/s.
a. This is a legacy setting for older storage arrays not supporting the Report LUNs command.
Table 4 Pre-configured parameters for 8 Gb/s and 16 Gb/s
Parameter
EMC-approved setting EMC-approved setting
8 Gb/s 16 Gb/s
Data Rate Auto Auto
Execution Throttle 65535 65535
Connection options Loop preferred, otherwise
point-to-point
Loop preferred, otherwise
point-to-point
Loop Reset Delay 5 5
Enable LIP Full Login Yes Yes
Enable Target Reset Yes Yes
Port Down Retry Count 45 30
Link Down Timeout 45 30
LUNs Per Target 256 128
a
Enable Hard Loop No No
Hard Loop ID 0 0
Operation Mode 0 0
Interrupt Delay Timer 0 0
Frame Size 2048 2048
Enable BIOS No No
Enable FC Tape Yes Yes
Login Retry Count 8 8
Enable Receive OoOFrame Yes Yes