Installation guide

Booting from the external storage array
47
Installation and Configuration
• At this point, the QLogic adapter instances should be shown
with a specific firmware version, and "AUX" should not be
listed next to the firmware, as shown in Figure 25.
• At this point, the EFI drivers, firmware, and NVRAM settings
have loaded to the adapter(s).
Figure 25 QLogic adapter instances with specific firmware version
8. Type q and press Enter to exit the QLogic EFI Utility.
9. At the EFI shell prompt, type drivers and press Enter. Note the
entries that reference "QLogic Fibre Channel Adapter" are similar
to the listing shown in Figure 26.
Figure 26 QLogic Fibre Channel drivers
10. Make note of the first two digits (referred to as the "driver
handle") on the line that references the "QLogic Fibre Channel
Driver". If multiple adapters are installed in the server, there will
be multiple entries, as shown in Figure 26.
The order of the adapter instances listed is the order in which
they have been enumerated by the system. This does not
necessarily correspond to PCI slot numbering. In this example,
the two QLogic adapters installed in the server are using driver
handles 5F and 60, respectively.
a. Type
drvcfg.
b. Press Enter.