Installation guide

FCoE converged network adapter (CNA) procedures
97
Installation and Configuration
Installing Menlo firmware on a QLogic CNA
To install the Menlo encapsulation ASIC firmware on your FCoE
converged network adapter, follow these steps.
1. Start the SANsurfer utility, as shown in Figure 75, and click Open
your CNA.
2. In the left panel, under the CNA, click the FCoE Engine.
3. In the right pane of the SANsurfer utility, you will see
information about the CNA Menlo firmware.
Figure 75 SANsurfer utility