Installation guide

2 – Installation

Installation Tasks

2-18 D000024-001 Rev. B

NOTE:

When handling IB connectors, make certain to remove the connectors by

pulling on the center of the lanyard only as shown in Figure 2-16 below.

Pulling abruptly on the lanyard, or pulling on only one side of the lanyard

will prevent the latch/unlatch operation from occurring, and could damage

or break the lanyard.

Figure 2-16 4X IB Cable Connector

3. Connect FVICs to Fibre Channel devices using Fibre Optic cables.

Connecting Power

1. Provide strain relief for the power cable(s).

NOTE:Be certain that the power cords are firmly seated into the AC power inlets..

2. If necessary, replace the fascia(s) over the switch fans.

3. Connect the power cables to an AC power outlet.

4. When the switch is plugged into an AC power outlet:

a. The system powers up.

b. The fans start.

c. The system performs a power-on self test (POST).

5. The switch, power supply, and fan LEDs light up.