Manual

ManualsBrandsQmark ManualsFans1047 General Home/Kitchen Fans

READ AND SAVE THESE INSTRUCTIONS

1047

VENTILATOR

DESCRIPTION

The Model 1047 gives automatic through-the-wall ventilation. It allows placement of the ventilator over

the kitchen range and has a chain operated switch and door assembly. Care must be taken at all times

in handling the motor blade assembly to avoid bending the blades.

UNPACKING

Unpack carefully. If there are missing components or hidden damage, immediately contact your

distributor or the delivering carrier concerning discrepancies.

IMPORTANT SAFETY INSTRUCTIONS

WARNING:

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK

OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1. Do not use this fan with any Solid-State speed control device.

2. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer.

3. Before servicing or cleaning unit, switch power off at service

panel and lock service panel to prevent power from being

switched on accidentally.

4. Installation work and electrical wiring must be done by

qualified person(s) in accordance with all applicable codes and

standards, including fire-rated construction.

5. Sufficient air is needed for proper combustion and exhausting

of gases through the flue (chimney) of fuel burning equipment

to prevent back drafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as those

published by the National Fire Protection Association (NFPA),

and the American Society for Heating Refrigeration and Air

Conditioning Engineers (ASHRAE), and the local code

authorities.

6. When cutting or drilling into wall or ceiling, do not damage

electrical wiring or other hidden utilities.

7. CAUTION: For General Ventilating Use Only! Do not use to

exhaust hazardous or explosive materials and vapors.

8. CAUTION: To reduce risk of fire and to properly exhaust

air, be sure to duct air outside. DO NOT vent exhaust air

into spaces within walls, ceilings, attics, crawl spaces or

garages. DO NOT install sleeve or duct in a fire rated wall.

DIMENSIONS

⁄4”

⁄8”

11”

14”

Summary of content (4 pages)

PAGE 1
READ AND SAVE THESE INSTRUCTIONS 1047 VENTILATOR DESCRIPTION The Model 1047 gives automatic through-the-wall ventilation. It allows placement of the ventilator over the kitchen range and has a chain operated switch and door assembly. Care must be taken at all times in handling the motor blade assembly to avoid bending the blades. UNPACKING Unpack carefully. If there are missing components or hidden damage, immediately contact your distributor or the delivering carrier concerning discrepancies.
PAGE 2
TOOLS FIGURE 2 Installation of your Marley product is easy. No special technical knowledge is needed. Only a few ordinary tools are required: Screwdriver Hammer Saber saw, Keyhole saw, or Jig saw Electric drill with bit Wire cutters Wire stripper Wire nuts and general electrical supplies Safety glasses Ruler and straight edge All hand tools should be insulated. Power tools should display the UL Listing Mark. 1” MIN. NEW HOME INSTALLATION 1.
PAGE 3
TO INSTALL IN EXISTING HOMES 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Determine location of ventilator. Check wall for studs and obstructions. Work on inside wall first. Draw a circle 11-1/8” in diameter at determined location. Be sure opening is at least 1” from the studs. (See Figure 2.) Carefully saw opening in plaster. Remove just enough insulation to allow sleeve to pass through, exposing sheathing. Mark the center of the hole on the sheathing. At this point, drill small hole to outside.
PAGE 4
LIMITED WARRANTY Dear Customer, Thank you for your interest in Marley Engineered Products bath fans. We’re sure you will enjoy its benefits for many years to come. Please take a minute to fill out the following information and keep it in your permanent records. Date Purchased Date Installed Model Number Serial Number LIMITED WARRANTY This Marley Engineered Products bath fan is warranted to be free of defects in material and workmanship for 12 months from date of original purchase.