Accessories Manual

®
OPERATING INSTRUCTIONS
MODEL: 12006 - 6 AMP - 120 VOLT 50/60 Hz
READ CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE, OR SERVICE ADJUSTABLE SPEED CONTROLS!
RETAIN INSTRUCTIONS FOR FURTHER REFERENCE.
Installation
1. Turn power off at circuit breaker panel or fuse box.
2. Mount control to standard single gang wall box.
3. Run conduit between the wall box, power source,
and the fan units being controlled. Leave approxi-
mately six inches of wire in the box for connections
(See Figure 1).
4. Make wiring connections as shown in Figure 2.
Connect the black from the 120V supply to one black
of the control. Connect the second black of the con-
trol to the black from the fan motor. Connect the
white from the 120V supply to the white of the fan
motor. Connect green ground wire to wall box. Make
sure that the wire strands are straight and attach the
wire leads of the control to the circuit wires by twist
ing them together. Twist a wire nut onto each con-
nection.
5. Check all connections for tightness; leave no
exposed copper conductor.
6. Position connections in box, leaving room for control.
7. Install speed control in wall box using screws sup-
plied.
8. Attach control knob by pressing onto shaft firmly.
9. Restore power at circuit breaker panel or fuse box.
10. Turn control on. Starting on high, turn clockwise to
decrease speed smoothly to low speed.
General Safety Information
WARNING: DISCONNECT POWER SUPPLY BEFORE
WIRING CONNECTIONS ARE MADE TO PREVENT
POSSIBLE ELECTRICAL SHOCK OR DAMAGE TO
EQUIPMENT.
WARNING: READ AND FOLLOW INSTRUCTIONS
CAREFULLY. FAILURE TO COMPLY WITH INSTRUC-
TIONS COULD RESULT IN FIRE, ELECTRICAL
SHOCK, INJURY TO PERSONS, AND/OR DAMAGE
TO EQUIPMENT.
1. All wiring should conform to the National Electrical
Code and local regulations.
2. Do not mount in an area which will allow the control
to come in contact with moisture.
3. Make certain the entire installation is grounded as a
precaution against possible electrical shock.
4. Do not exceed maximum amperage rating of the
control as overloading can result in damage to
ceiling fan and control.
Adjustable Speed
Controls
-
CONTROLS
56”/220/277
5600-2/5600-7
UNITS
Figure 1
Figure 2
3
CONTROLS
60”/120
6000-1/6010-1
UNITS
5
CONTROLS
56”/120
5600-1/5600-1LC
5630-1RDP-UNITS
5
CONTROLS
48”/120
4820-1
UNITS
6
AMPS
120
VOLTS
12006
MODEL
NUMBER
7
CONTROLS
36”/120
3620-1
UNITS