Accessories Owner manual

OPERATING INSTRUCTIONS
MODELS: 12003, 12008, 12012, 22003,
22008, 22012, 27703, 27708, 27712
READ CAREFULLY BEFORE ATTEMPTING TO INSTALL, OPERATE, OR SERVICE ADJUSTABLE
SPEED CONTROLS!
RETAIN INSTRUCTIONS FOR FURTHER REFERENCE.
Description
Leading Edge solid state adjustable speed controls are
engineered and designed specifically for use with
Leading Edge commercial/industrial ceiling fans.
Controls provide adjustable speed operation at any point
between minimum and maximum fan speeds. All models
have a hard plastic backing to protect components and
circuit board and dial on/off switch. 3 Amp control Model
features brushed aluminum wall plate. 8 and 12 Amp
controls feature a finned aluminum heat sink plate, wire
brushed gold finish and black trim. All models are UL
Listed.
General Safety Information
WARNING: DISCONNECT POWER SUPPLY BEFORE
WIRING CONNECTIONS ARE MADE TO PREVENT
POSSIBLE ELECTRICAL SHOCK OR DAMAGE TO
EQUIPMENT.
WARNING: READ AND FOLLOW INSTRUCTIONS
CAREFULLY. FAILURE TO COMPLY WITH INSTRUC-
TIONS COULD RESULT IN FIRE, ELECTRICAL
SHOCK, INJURY TO PERSONS, AND/OR DAMAGE
TO EQUIPMENT.
1. All wiring should conform to the National Electrical
Code and local regulations.
2. Do not mount in an area which will allow the control
to come in contact with moisture.
3. Make certain the entire installation is grounded as a
precaution against possible electrical shock.
4. Do not exceed maximum amperage rating of the
control as overloading can result in damage to
ceiling fan and control.
Adjustable Speed
Controls
Models 12003
22003
27703
Models 12008
22008
27708
Models 12012
22012
27712
3 Amps
8 Amps 12 Amps
MODEL
NUMBER
12003
12008
12012
22003
22008
22012
27703
27708
27712
CONTROLS
36”/120
3620-1
UNITS
3
10
12
AMPS
3
8
12
3
8
12
3
8
12
VOLTS
120
120
120
220
220
220
277
277
277
CONTROLS
48”/120
4820-1
UNITS
2
6
10
CONTROLS
56”/120
5600-1
5600-1LC
5630-1RDP
5610-1
UNITS
2
6
10
CONTROLS
56”
220/277
5600-2
5600-7
UNITS
2
6
8
2
6
8
CONTROLS
60”/120
6000-1
6010-1
UNITS
1
4
8
SPECIFICATIONS AND
RECOMMENDED CONTROL
CALCULATIONS PER FAN MODEL