Installation Guide

7
TROUBLESHOOTING GUIDE
Problem Cause Solution
Fan stays on when heat shuts off. 1. Fan delay cycles On/Off
until elements are cool
1. Heater is operating correctly for models.
Heating element does not glow red 1. Heating element is made of
stainless steel and will not glow red
to produce heat.
1. Heater is operating correctly.
Do not feel heat or air flow 1. No Power to heater
2. Desired room temperature reached.
3. Heater does not heat area in front
of heater, it will disperse heat
throughout room and heat entire
space.
1. Check power connections / connect
heater to power supply.
2. Thermostat will shut off once desired
room temperature is reached. Heater is
operating correctly.
3. Heater is operating correctly.
MAINTENANCE - INSTRUCTIONS
User Cleaning Instructions:
1. After the heater has cooled, a vacuum cleaner with brush attachment may be used to remove dust and lint from exterior surfaces of the heater including
the grille opening. Compressed air may also be used to blow out dust from inside heater.
2. With a damp cloth, wipe dust and lint from grille and exterior surfaces. Be careful not to let the water enter the inside of appliance.
3. To protect the enclosure, don’t splash water onto the heater, and never use solvents to clean the heater.
4. Return power to heater and check to make sure it is operating properly.
Maintenance Cleaning Instructions:
(To be performed only by Qualified Service Personnel)
At least annually, the heater should be cleaned and serviced by a qualified service person to assure safe and efficient operation. After completing the cleaning
and servicing, the heater should be checked for proper operation.
The remote control is powered by 2 AAA batteries. These should be replaced periodically or at least annually.