User Manual

1. After programming the USB Wall Station Timer will function as a clock with the
time set to the system clock of the computer used to program it.
2. At the times set for each Event the remote will signal the shade to go to wherever
was selected by the Action box for the Event as long as the current day of the
week was checked off.
Note: The Events will occur in order based on the times set and not the order of
the events.
3. You can also manually use your USB Wall Station Timer remote like a standard
wall station remote as referenced in the user manual that came with your shade
under Remote Control Operation. Also learning the remote to a shade is the same
procedure referenced in the Adding A New Remote Control in the user manual
that came with your shade.
MADE IN C
HINA
Model: QR1051433
Product: Q0514
FCC ID: X6P-0003441
IC: 8832A-0003441
HomeRun Holdings Corp. 3400 Copter Rd. Pensacola, FL 32514
QMotion Customer Support
 http://www.qmotionshades.com [e-mail]

Toll Free 1
-
877
-
849
-
6070
Warning: Changes or modifications to this device not expressly approved by HomeRun Holdings Corp. could void the user’s authority to operate the
equipment.
FCC REGULATORY STATEMENTS
“NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the
equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for
help.”
INDUSTRY CANADA REGULATORY STATEMENTS
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential radio interference to other users the antenna type and its gain should be chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than necessary for successful communication.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1) This device may not
cause harmful interference and, 2) this device must accept any interference received, including interference that may cause undesired operation.