User's Manual

PRELIMINARY

ZigBee Remote Programming Instructions

12345

Front

Back

DOWN

CHANNEL

20%

40%

60%

80%

PROGRAM

Pin Hole

READ AND UNDERSTAND EACH SECTION BEFORE PERFORMING REQUIRED STEPS

Most programming instructions start with the shade in the upper limit position. If a remote is paired to the shade, pushing

the UP button will send the shade to the Upper Limit Position. If no remote is paired to the shade, remove the Honey-

comb fascia, slide out the motor and battery holder and push the shade up manually. Replace the motor and fascia.

JOG is a short up then down shade movement.

IMPORTANT

FIRST TIME SETUP

1. INSTALL SHADE following appropriate installation instructions

2. Remove battery enclosure cover and pull the plastic battery tab

3. On power-up the shade automatically enters PAIRING / LEARN MODE

4. Use a paperclip to PRESS the PROGRAM button on back of the remote

(The channel LEDs will scroll back and forth when in program mode)

5. PRESS and HOLD the UP button until Shade moves downward

PAIRING / LEARNING NEW REMOTES (or Channel)

(Must start using paired remote with shade at Upper Limit Position)

STEPS 1- 3 use paired remote

1. Use a paperclip to PRESS the PROGRAM button on back of the remote

(The channel LEDs will scroll back and forth when in program mode)

2. PRESS and HOLD the UP button until Shade moves downward

3. TUG the shade 6-10 inches (Shade will JOG in response)

STEPS 4- 6 use unpaired remote

4. PRESS the CHANNEL button until desired Channel is lit by GREEN LED

5. Use a paperclip to PRESS the PROGRAM button on back of the remote

(The channel LEDs will scroll back and forth when in program mode)

6. PRESS the UP button (Shade will move to Upper Limit Position in response)

SETTING UPPER AND LOWER LIMITS / LEARNING A NEW POSITION

1. PRESS the (UP, DOWN, or PERCENT) button that will be programmed (Shade will move to selected position)

2. PRESS and HOLD the same (UP, DOWN, or PERCENT) button until shade JOGS

3. TUG shade 6-10 inches (Shade will JOG in response)

4. ADJUST shade to desired position ( Use UP/DOWN buttons or manually adjust shade by hand)

5. PRESS and HOLD the same (UP, DOWN, or PERCENT) button (Shade will JOG when learned)

IMPORTANT

Lower Limit Position must be set prior to using the PERCENT positions (20%, 40%, 60%, 80%). These positions are

calculated based on the Lower Limit Position of the shade.