User's Manual

6
PRELIMINARY
12345
CH
Front
Back
UP
DOWN
CHANNEL
20%
40%
60%
80%
PROGRAM
Pin Hole
DELETE / UNLEARN A REMOTE (or Channel)
(Shade at Upper Limit Position)
1. Use a paperclip to PRESS the PROGRAM button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2. PRESS and HOLD the UP button until Shade moves downward
3. TUG the shade 6-10 inches (Shade will JOG in response)
4. PRESS the CHANNEL button until desired Channel is lit by GREEN LED
5. Use a paperclip to PRESS the PROGRAM button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
6. PRESS the DOWN button
(Shade will JOG, move to Upper Limit Position, and then JOG again)
SPECIAL LEARN COMMAND
(Must use an unpaired remote with shade at Upper Limit Position)
1. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2. PRESS and HOLD the CHANNEL button until the shade moves
3. TUG the shade 6-10 inches (The shade will JOG in response)
4. Use a paperclip to PRESS the PROGRAM button on the back of the remote
(The channel LEDs will scroll back and forth when in program mode)
5. PRESS the UP button
(The shade will travel to the Upper Limit Position to confirm learn command)
BATTERY CHANGE / POWER CYCLE
1. REMOVE the FASCIA cover to expose the battery holder
2. REPLACE batteries with a new set of fresh D-Cell Alkaline batteries
3. POWER CYCLE is performed by removing a single battery, and then tugging the shade 5 inches
4. INSERT batteries and REPLACE FASCIA cover
FACTORY (MASTER) RESET (Will remove ALL paired remotes, EXCEPT remote and channel used during reset)
(Shade at Upper Limit Position)
1. Use a paperclip to PRESS the PROGRAM button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
2. PRESS and HOLD the DOWN button until shade moves downward
3. TUG the shade 6-10 inches (Shade will JOG in response)
4. Use a paperclip to PRESS the PROGRAM button on back of the remote
(The channel LEDs will scroll back and forth when in program mode)
6. PRESS the UP button (Shade will move to Upper Limit Position in response)
READ AND UNDERSTAND EACH PROGRAMMING SECTION BEFORE PERFORMING REQUIRED STEPS