User Manual

13
SELECTING THE INTERFACE (RS232, RS485, DRY CONTACT)
The Qconnect Bridge comes from the factory set for RS232 operation.
To change the mode to RS485, follow these steps:
a) Unplug the power supply
b) Hold the DOWN button
c) Still holding the DOWN button plug the power supply back in
To change the mode to Dry Contact, follow these steps:
d) Unplug the power supply
e) Hold the UP button
f) Still holding the UP button plug the power supply back in
To change the mode to RS232, follow these steps:
g) Unplug the power supply
h) Turn the rotary switch to ‘0’
i) Plug the power supply back in