Product Guide 2014 NEW.
Contact Address PO Box 1168 Hedley Road St Albans Hertfordshire AL1 9WY United Kingdom T: 0845 450 1606 e: info@qmotionshades.co.uk Website www.qmotionshades.co.uk info@qmotionshades.co.uk Phone Customer Service Number: 0845 450 1606 Product Guide 2014 NEW.
Table of contents Features................................................................. 1 Options.................................................................. 2 Shade Information.................................................. 3 Low Voltage Transformer Information...................... 4 Shades.................................................................. 5 Qlink Shades......................................................... 6 Mounting Brackets................................................
Features QMotion UK offers state-of-the-art natural light control with the following benefits: • Industry leading light gaps on the sides of the shades as small as 13mm gap on each side, providing the most uniform and highest level of window coverage. Several different control options • QMotion UK Shades offer the convenience of moving the shade up or down, stopping at any of the top, the bottom, three programmable intermediate stops, or anywhere in between; all with the ease of a button press.
Options QMotion UK advanced shading solutions allow for a customised experience. The look you want The choice you prefer • QMotion UK shades offer several choices of fascia or cassette to conceal the top of the roller shade. • Transformer low voltage power supply is a wired power solution for those who want the benefits of QMotion UK automated shades with a connection to the properties electrical system. Available in a single unit, or one which can power and control multiple shades.
Shade Information Finally, the luxury and safety of automated shades, completely free of cords and wires, are accessible to everyone. Order specifics Fabric orientation and size • Shades ship complete with brackets and batteries, as needed, ready to install. • Shades may be specified standard or reverse roll. • If desired, a 24v low voltage transformer power option may be specified. • All shades ship with fabric oriented in the vertical roll direction from the mill.
Low Voltage Transformer Information QMotion UK Low Voltage shades offer all the same features of QMotion UK Battery powered shades, and are compatible with fascia as well as controls. • Battery tube is replaced with transformer leads. • Each shade comes with a 600mm wire lead. • Tube is configured to convert low voltage into the proper level to power the shade. • Power supply options are available to power one shade or multiple shades.
Shades The design of QMotion UK delivers a simple, sophisticated automated shade that offers both ease of use and dependability. • Low voltage wired shades can accommodate left or right side connection. • Longer battery life. • Extended range and enhance responsiveness to transmitters. - 9 metres or more in most applications (each installation is different, and environmental factors may effect results.) • Improved functionality with remotes.
Qlink Coupled Shades available early 2014 Qlink By using the Qlink coupling system, shades can cover spans as wide as 9 metres with a single motor. The linked shade’s unique coupling system supports 19mm minimum light gap and angles up to 40 degrees. • Multi-window covering up to seven bands without wiring, or use our low voltage system. • Manual override option - shade can be operated manually at all times. • Shades retain long battery life. • Adjustable installation brackets for proper shade leveling.
Mounting Brackets Elegant fabrics, clean lines and modern finishes create natural beauty for every window. Seven styles Default brackets • There are seven different mounting brackets offered depending on application requirements: 2.6 Universal 3.3 Universal 2.5 Dual Shade 3.7 Dual Shade • Non-fascia shades ship with universal brackets. • Outside mount shades ship with outside mount brackets. • Pocket applications are best served with our fascia. • Dual shade applications ship with dual brackets. 3.
Fascia Fascia will add a special finishing touch. Pocket Closure Including fashionable, colour co-ordinated fascias will enhance both the form and function of your QMotion UK Shades. Easily mounted either inside or outside the window width, fascias attractively conceal the shade system while adding to the light protection your shades were designed to provide. So they are attractive and practical, all in one.
Battery Life and Range Expectations QMotion UK Shades offer the longest battery life in the industry. QMotion UK Shades lead the industry in battery life • QMotion UK uses patented techniques to manage the weight of the shade as it is lowered. Because of this, it takes very little energy to run our shades up and down,meaning very low usage of the batteries. • Battery life is dependent on shade usage and shade size.
Cassette Shades QCassette The QMotion UK Cassette is formed of two extruded parts. The top and back extrusion is a durable structural aluminum, designed to mount securely and retain the QMotion UK system. The face plate is a laminated vinyl material engineered to be durable and attractive, while making installation and battery changes simple. QMotion UK motorised Cassette Roller Shades are powered by the same innovative battery saving technology used in all of our roller shades.
Accessories Finishing touches for a beautiful QMotion experience. Aluminium Fascia • Fascia is available in any of the 5 standard colours. (White, Silver, Sand, Bronze, Black). • All fascia includes light sealing white or black colour wool pile to further assist in light blocking on the top of the shade. • To ensure proper fit and function, inside mount fascia are cut 2mm less than the top window width. Outside mount fascia are cut 6mm larger than the bracket to bracket dimensions.
QMotion UK Controls QMotion UK Single Channel 5 Button Remote • • • • 5 buttons to support up, down, 25% 50%, 75% Magnetic back for simple storing to wall plates Controls unlimited number of shades in a group Normal remote range: 9 metres UP 25% 50% DOWN 75% QMotion UK Programmable Timer Remote • Programmed automated settings in addition to the single channel 5 button remote controls • Low transmission power, must locate close to shades or Qrelay • Supports as many as 6 events • Windows PC programmabl
QMotion UK Qconnect The Qconnect Interface is a bridge between our language and most building or home automation systems. With drivers for many popular systems, and easy programming tools, clients can easily drive QMotion UK Automated shades with their new or existing control systems.
QMotion UK Qsync QMotion UK Smartphone Application “App” Features: s. • Control QMotion® UK shades with iOS or Android mobile devices. • Virtual Shade: Drag your finger to place the shade to the desired positions • Connects automatically to Wifi* and Bridge. “Plug and Play” • Channel System to name, take and set reference photo to group shades.
QMotion UK Wall Docking Station For the convenience of the user, consider QMotion UK Wall Docking Stations. Available in Single, Double or Triple gang versions, these wall plates are built to install on a wall as a place to retain the transmitters used in a project. Remote controls hold in place on the Docking Station via a strong magnet, and allow the remote controls to be used as a wall switch for a third level of control for the shades.
Customer’s Own Material (C.O.M.) In circumstances where the QMotion UK Shades fabric assortment is not similar to a desired material, customers may supply the fabric for the shade, and QMotion UK will manufacture the shade using this material. Often this is not using roller shade fabric and performance will vary with the type of finish of the fabric. Please verify with your fabric supplier that the fabric can perform properly on a flat roller shade.
QMotion UK Measurement Instructions Inside Mount Outside Mount Measure and assess area to be covered: · Measure opening to be covered vertically and horizontally in three places. · If vertical measurements vary more than 13mm we recommend an outside mount. · If horizontal measurements vary more than 13mm we recommend an outside mount. · Measure and compare diagonals to determine if opening is square. · If corner to corner diagonal measurements vary more than 13mm we recommend an outside mount.
QMotion UK Measurement Instructions (cont.) Required order form measurements for INSIDE MOUNT: · Use the top horizontal measurement for TOP WIDTH. This is outside of bracket to outside of bracket. · Use the largest vertical measurement for HEIGHT. · Measure and record DEPTH. Use the minimum distance from the outside of opening to the window including window mullions if they exist. This is important in determining if the shade and fascia will protrude into the room and out of the opening.
QMotion UK Automated Shades Reference Information 19 Product Guide 2014 NEW.
QMotion UK Setting Hembar Position For shades produced on or after April 15th, 2013. Setting Any Position Location QMotion UK shades produced after April 15, 2013 have the additional ability to program the upper stop position. These instructions may be followed the same for each button programming operation, substituting the desired button to be programmed during this process. 1. 2. 3. Send the shade to the position to be changed.
QMotion UK Remote Settings For shades produced on or after April 15th, 2013. Adding or Deleting a Remote 1. 2. 3. 4. Send the shade to Top/Upper limit. Press & Hold the UP button after the shade has stopped. After about 5 seconds the shade will jog down 75mm and back up. Keep holding the UP button, do not release. After about 10 seconds the shade will start traveling to the 75% position a. Release the Up button. b. After the shade stops at 75%, tug the shade 150mm. The shade is now in learn mode. i.
QMotion UK Remote Settings For shades produced on or after April 15th, 2013. Factory Reset Then Adding a Remote 1. 2. 3. 4. 5. Send the shade to Top/Upper limit. Press & Hold the UP button after the shade has stopped. After about 5 seconds the shade will Jog down 75mm and back up. Keep holding the UP button, do not release. After about 10 seconds the shade will start traveling to the 75% position. Keep holding the UP button, do not release.
Brackets (Universal Back/Face Mount) 2.6 Universal Bracket Back/Face Mount, No Cover 88mm 67mm 35mm 70mm 2.6 Universal Bracket Back/Face Mount, Cover 90mm 67mm 40mm 75mm 2.6 Universal Bracket Back/Face Mount, No Cover, Reverse 96mm 67mm 35mm 70mm 23 Product Guide 2014 NEW.
Brackets (Universal Back/Face Mount) 2.6 Universal Bracket Back/Face Mount, With Cover, Reverse 96mm 67mm 40mm 75mm 3.3 Universal Bracket Back/Face Mount, No Cover 96mm 83mm 35mm 70mm 3.3 Universal Bracket Back/Face Mount, With Cover 96mm 40mm 83mm 75mm 24 Product Guide 2014 NEW.
Brackets (Universal Back/Face Mount) 3.3 Universal Bracket Back/Face Mount, No Cover, Reverse 111mm 83mm 35mm 70mm 3.3 Universal Bracket Back/Face Mount, With Cover, Reverse 111mm 83mm 40mm 75mm 25 Product Guide 2014 NEW.
Brackets (Universal Top Mount) 2.6 Universal Bracket Top Mount, No Cover 35mm 78mm 67mm 88mm 2.6 Universal Bracket Top Mount, With Cover 81mm 40mm 67mm 89mm 26 Product Guide 2014 NEW.
Brackets (Universal Top Mount) 3.3 Universal Bracket Top Mount, No Cover 85mm 35mm 83mm 96mm 3.3 Universal Bracket Top Mount, With Cover 89mm 40mm 83mm 97mm 27 Product Guide 2014 NEW.
Dual Brackets 71mm 54mm 2.5 Dual Bracket 33mm 48mm *Standard roll application only 63mm 63mm 137mm 79mm 97mm 103mm 78mm 37mm 87mm 87mm 3.7 Dual Bracket 190mm *Standard roll application only 102mm 133mm 28 Product Guide 2014 NEW.
Qlink (coming early 2014) Bracket 2.5 54mm 33mm 36mm 63mm Universal Bracket 70mm 71mm 54mm 33mm 63mm Outside Mount Bracket 70mm 71mm 94mm 33mm 86mm Pocket/Reverse Bracket 63mm 76mm 48mm 71mm 29 Product Guide 2014 NEW.
Qlink (coming early 2014) Brackets 3.7 70mm 33mm 56mm 94mm 86mm Universal Bracket 102mm 124mm 33mm 116mm Pocket/Reverse Bracket 90mm *Some installations may require L-Bracket 94mm 63mm 102mm 30 Product Guide 2014 NEW.
Fascia Brackets 2.6 Fascia Bracket 29mm 84mm 67mm 41mm 87mm 46mm 46mm 3.3 Fascia Bracket 38mm 102mm 83mm 29mm 51mm 105mm 71mm 54mm 46mm 148mm 4.3 Fascia Bracket 29mm 110mm 63mm 148mm 68mm 73mm 60mm 31 Product Guide 2014 NEW.
Cassette Single Cassette 98mm 92mm 76mm Qlink (coming early 2014) 71mm 87mm 63mm * R.U.D. indicates the maximum likely diameter on the system. Check fabric charts for specific shade diameters. 32 Product Guide 2014 NEW.
QMotion UK Fascia 140mm 113mm Dual Bracket Fascia 103mm 76mm 35mm 35mm 146mm 208mm 33 Product Guide 2014 NEW.
QMotion UK Fascia (2.6) 86mm 67mm Standard Fascia 89mm 86mm 67mm Reverse Fascia 89mm 34 Product Guide 2014 NEW.
QMotion UK Fascia (3.3) 83mm Standard Fascia 103mm 106mm Reverse Fascia 83mm 103mm 106mm 35 Product Guide 2014 NEW.
QMotion UK Fascia (4.3) 110mm 133mm Standard Fascia 132mm Reverse Fascia 110mm 133mm 132mm 36 Product Guide 2014 NEW.
Qlink Fascia (coming early 2014) 3.7 Standard Fascia 127mm 100mm 35mm 116mm 3.7 2.5 Reverse Fascia 140mm 113mm 103mm 76mm 35mm 35mm 83mm 117mm 37 Product Guide 2014 NEW.
Copyright Notice and Disclaimer All rights reserved. No parts of this manual may be reproduced in any form without the express written permission of QMotion UK. QMotion UK makes no representations or warranties with respect to the contents hereof. In addition, information contained herein are subject to change without notice. Every precaution has been taken in the preparation of this manual.
Limited Warranty QMotion UK, (the “Manufacturer”) warrants that this QMotion UK window shade product will be free from defects in materials and workmanship for 5 years, beginning from the date first sold to the commercial or residential consumer who has, or intends to, use the product, as evidenced by such consumer’ proof of purchase: Exclusions From this Limited Warranty: This limited warranty shall be null and void and no part of it shall apply if any one of the following occur: 1) the product has not been
Claims for defects in material and workmanship covered by this Limited Warranty must be made in writing to the distributor from whom the product was originally first purchased within the warranty period stated above. Manufacturer may either send a service representative or have the product returned to Manufacturer’s facility, at Buyer’s expense, for inspection.
Product Guide 2014 NEW.