Technical information

Once you have changed the current input character, use the following
keys to move the cursor to another input character:
To exit from the character selection process, move the cursor to the
last character of the input field (the character farthest to the right) and
press the Select key, or move to the first character of the input field
(the character farthest to the left) and press the Menu key.
When you exit, the printer verifies character information and confirms
it in the message window. If character information is valid, you’re
returned to the previous menu; if it’s invalid, you’re returned to the
input field. Press the Menu key to cancel any changes to the charac-
ter information.
If the current character information is longer than the value that you
need to enter, replace each extra character with a space. The printer
interprets a space at the end of character information as a blank.
To change the HP-GL emulation scaling percent, press the control
panel keys in the order shown in the following table. The printer
responds by displaying a status message or configuration menu in
the message window. An underline indicates the current input charac-
ter in the message window.
Press this key to...
Select Advance the cursor to the next character.
Menu Return the cursor to the previous character.
Press this
key
to... The message
window reads...
Online/
Offline
Turn off the Online/Offline indicator and
readies the printer for configuration.
IDLE
Menu Access the configuration menu. CONFIGURATION
OPERATOR CONTROL
Next Advance to the Administration menu. CONFIGURATION
ADMINISTRATION