Technical information

Allows you to specify which jobs are printed first, according to the
interface through which they are received, when jobs are received
simultaneously.
Sets the binary communications protocol (BCP) for communicating
over a parallel interface to a PostScript printer.
Menu Administration/Communications/Parallel/Def Job Prio
Choices 001-100 (highest-lowest priority)
Default 001 (highest priority)
Notes For example, you can give jobs received via the parallel
interface priority over jobs received via the serial and Ethernet
interfaces.
Menu Administration/Communications/Parallel/PS Protocol
Choices Normal—Enable standard, ASCII hex protocol. Data is sent
and received in ASCII format. This mode is recommended if
you do not print binary data. It was designed for data in the
printable ASCII range. Print jobs can alter the PS protocol
value through PostScript operators.
Normal Fixed—Enable standard, ASCII hex protocol. Print
jobs cannot alter this value through PostScript operators.
Binary—Enable binary communications protocol. Print jobs
can alter this value through PostScript operators. Data in the
printable ASCII range also prints.
Binary Fixed—Enable binary communications protocol. Print
jobs can not alter this value through PostScript operators. Data
in the printable ASCII range also prints.
Default Normal
Notes See chapter 5, “Additional Technical Information,” for a full
discussion of PS Protocol.