User`s guide

Closing

CrownNet

Manager

QMS CrownNet System Administrator's Guide5-8

Closing CrownNet Manager

To close the CrownNet Manager for OS/2, double-click on the control

box.

Additional Technical Notes

n CrownNet Manager for OS/2 does not support printing from LAN

Server if NetBIOS-over-TCP/IP is activated because NetBIOS-

over-TCP/IP completely replaces the NetBEUI protocol stack.

Printing from LAN Server is fully supported if NetBEUI is used.

n NetBEUI must be enabled in LAN Manager. NetBEUI and TCP/IP

can be enabled and active at the same time.

n There is no definite limit to the number of CrownNet interface’s

supported by each server. Each CrownNet interface is seen as a

separate destination by a print queue and, in turn, by an applica-

tion. However, if many CrownNet interfaces are installed on the

network, the maximum number of NetBIOS sessions may have to

be increased in the NetBEUI setup.

n CrownNet Manager for OS/2 is completely transparent and does

not affect the data stream that passes through it. From an appli-

cation point of view, CrownNet Manager for OS/2, the CrownNet

interface, and printer together behave as though the printer is

directly attached to the server.

n Opening CrownNet Manager for OS/2 more than once on a

server can cause the server to hang.