Setup guide

,%-
!-
$
&$. 
5 Remove the two screws holding the metal
plate over the optional interface opening.
The optional interface opening is labelled
“Option.” It’s located next to the “Parallel” port.
Save the two screws. (You’ll use them when you
install the optional interface card.) You can dis-
card the plate.
6 Attach the interface card to the controller
board.
a Position the interface card so that its I/O
connector slides into its opening in the
interface panel and that its 80-pin connector
aligns with the 80-pin connector on the
controller board.
b Gently press the interface card down until its
connector is fully seated and the card is
secured by the plastic support post(s).


 Caution: Make sure that the connectors on
the interface card and controller board are
properly aligned. Damage to the interface
card and/or controller board could result if
the pins are misaligned.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]