Setup guide

.-1






























'
11 When the printer’s message window reads Idle again, the
emulation is ready to use.
The emulation should be listed in the Options section of the
printer’s startup page, in the Administration/Emulation printer’s
configuration menu, and on the advanced status page.
»Note:
You may want to erase any installation files left on your PC
(and/or workstation), and then remove any temporary directories.
)
Refer to the documentation that came with your emulation for config-
uration and usage instructions.

A CCITT emulation (Group 4, monochrome only) is available through
the QMS ImageServer option, which image-enables your printer,
allowing it to print many images at or near the rated engine speed and
eliminating the need for a computerdedicated to rasterizing images.
For complete information, refer to the documentation that comes with
the ImageServer option.
3
Optional fonts, such as the 65 ProCollection fonts for the HP emula-
tions on your printer and other special PostScript fonts, are available
as PostScript files on floppy disks. This section describes how to
download optional fonts from a floppy disk to the printer’s hard disk.
»Note:
At least one hard disk (internal or external) must be present on
your printer before you can download a font (from CrownAdmin). If
more than one hard disk is available, the font automatically installs
itself on the disk with the most free storage space.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]