Setup guide
/7
.
&*
/
For the printer to recognize one or more external storage devices,
each device must be turned on before you turn on the printer. If the
printer recognizes the device(s) and the startup page is enabled,
check to ensure that DISK ONLINE prints on that page. If the startup
page is not enabled, print a status page and check to see if DISK
ONLINE prints on that page.
If DISK ONLINE does not print, see chapter 8, “Troubleshooting
Printer Problems,” of the
Operation
manual for more information.
Properly installed devices also appear in the “Options” section of the
startup page (if it’s enabled) and on the status page as %%disk
x
%.
(
x
is a 7 for an internal IDE hard disk and 0-4 or 6 for any external
SCSI hard disks or drives, depending on the SCSI ID set on the back
of the device. SCSI ID 5 is reserved for the CrownCopy scanner.)
012
Keep the following in mind when using Jaz and Zip drives:
Data can be backed up only to Jaz and Zip drives, not to external
SCSI hard disks.
Jaz and Zip drive information shows up on the startup and status
page only if media is present in the drive.
If a Jaz or Zip drive is attached to the printer but no media is
present, you will experience a long delay (30 seconds or more)
when you take the printer off line and put it back on line.
Jaz and Zip drives cannot be used for disk swapping or
accounting. They can be used only for font and file storage and
for data backup and restoration.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500