Setup guide

1
)&%#



 Caution: CrownCopy requires a minimum of 64 MB of RAM installed
on the printer.
1 Turn on the scanner, wait 5 seconds, and turn on the printer.


 Caution: The scanner must be turned on first so the printer can
recognize the scanner’s presence.
8 Insert the copy key into the “Key” port on the
printer interface panel.
You can’t access the CrownCopy menu unless
the copy key is inserted. The printer can be
either on or off.


 Caution: Even though both the copy key and
serial interface have a DB-9 interface, the
connectors are keyed, and they can’t be
interchanged. Make sure that you install the copy
key only in the port marked “Key.”
Your CrownCopy scanner is now ready to use. If
necessary, access the Copier Menu on the printer to
configure the scanner. For complete information on
adjusting copy settings, see “Menu Configuration” on
page 7-9.
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]