Installation guide

3
magicolor
6100 Print System (continued)
'!""(&""$ """
Open the two cleaning
roller lock levers by rotating
them toward each other.
Push the two tension
release levers toward the
rear of the printer.
»Note:
The printer is
shipped with the tension
release levers in the
forward position.
Install the cleaning roller in
its slot.
Close the two lock levers.
Open the two oil bottle lock
levers by rotating them
away from each other.
Insert the new oil bottle with
the nozzle pointed down.
Close the two lock levers.
Close the printer’s top and
front covers.
($)$ 
Unpack the media cassette.
Adjust the media guides to
fit the size paper you’re
loading.
Squeeze the retainers at
the ends of the left guide,
move the guide to the
appropriate location (media
sizes are listed on the
cassette).
Release the retainers.
Squeeze the retainers at
the ends of the center
guide, and move the guide
to the appropriate location.
Release the retainers.
Push the media pressure
plate down to lock it in
position.
Fan a stack of approx-
imately 250 sheets
(
½ ream) of letter-size
paper.
Load the paper.
Caution:
The paper should
fit easily between the
guides. Make sure the
paper corners are not bent.
A fill limit mark is provided
on the inside left side of the
cassette.

Caution:
Do not over-
fill the cassette.
The paper should face up
with its top toward the right
of the cassette.
Slide the media cassette
back into the printer.
*!""+($,(-

Caution
: Unplug the printer’s AC power cord before performing the following
steps.
(Skip to “I. Connecting Interface and Power Cables” if you didn’t purchase a lower
input feeder or duplex unit.)
Check the lower input feeder kit contents:
• Input feeder unit
• Universal media cassette
• One small metal bracket with thumbscrew (attached to LFU)
• Two plastic side covers
Remove the feeder from the shipping carton.
» Note:
One or two lower feeder units may be installed on the magicolor 6100
Print System. The following steps apply to both single and dual LFU kit
installations except where noted.

WARNING!
If consumables are installed, be sure to keep the printer
level when moving it to prevent accidental spills.
ACHTUNG!
Achten
Sie bitte darauf, das der Drucker mit eingebauten
Tonerkartuschen nur waagerecht transportiert wird.
Move the LFU(s) to a table
or flat surface near the
printer.
Position the LFU cable
connector away from the
rear of the LFU.
1
&
'%
!$%
2
3
&
4
#&!(
1
!(
)"("
2
3 4
1 2
EDNord - Istedgade 37A - 9000 Aalborg - telefon [phone]