User manual

6. Grasp the edge of the memory module. Align the notch on the gold edge of the

module with the notch in the memory slot. Slide the memory module to the slot at a

45-degree angle (approximately).

7. Gently press the memory module into the slot until it is seated fully.

8. Rotate the memory module towards the motherboard until the securing clips clicks into

place.

9. Close the case cover and fasten the screws. Connect the power adaptor and cables

back to the NAS.

10. To check that the memory module is recognized by the NAS, power up the NAS and

Information” and check the total memory in “Hardware Information”.