User manual
112
SSH
Qsync for Windows
Netbak Replicator
To use this function, select the option "Enable IPv6" and click "Apply". The NAS will restart.
After the system restarts, go to the IPv6 page. The settings of the IPv6 interface will be
shown. Click the "Edit" button to edit the settings:
IPv6 Auto Configuration:
If an IPv6 enabled router is available on the network, select
this option to allow the NAS to automatically acquire the IPv6 address and
configurations.
Use static IP address:
To use a static IP address, enter the IP address (e.g.
2001:bc95:1234:5678), prefix length (e.g. 64), and the gateway address for the NAS.
Contact your ISP for the prefix and the prefix length information.
o
Enable Router Advertisement Daemon (radvd): To configure the NAS as an IPv6 host
and distribute IPv6 addresses to the local clients which support IPv6, enable this
option and enter the prefix and prefix length.
IPv6 DNS server:
Enter the preferred DNS server in the upper field and the alternate
DNS server in the lower field. Contact the ISP or network administrator for the
information. If IPv6 auto configuration is selected, leave the fields as "::".
Service Binding
NAS services run on all available network interfaces by default. You can bind services to one
or more specific network interfaces (wired or wireless). Available network interfaces on the
NAS will be shown. Select at least one network interface that each service should be bound to.
Then click "Apply". Users will only be able to connect to services via the specified network
interfaces. If the settings cannot be applied, click "Refresh" to list the current network
interfaces on the NAS and configure service binding again.
Note:
Service binding is only available for NAS models with multiple network interfaces (wired
and wireless.)
After applying service binding settings, the connection of currently online users will be
kept even if they were not connected to services via the specified network interfaces.
The specified network interfaces will be used for the next connected session.
Proxy
Enter the proxy server settings to allow the NAS to access the Internet through a proxy
server to update the firmware, get new virus definitions, and to download Apps.