User manual

118
Hardware
Go to "Control Panel" > "System Settings" > "Hardware" to configure the NAS hardware
functions.
General
 Enable configuration reset switch: When this is enabled, you can press the reset
button for 3 seconds to reset the administrator password and the system settings to
default (NAS data will be retained) or 10 seconds for advanced system reset.
o Basic system reset: You will hear a beep after pressing and holding the reset button.
The following settings will be reset to default:
 System administration password: admin.
 TCP/IP configuration: Obtain IP address settings automatically via DHCP.
 TCP/IP configuration: Disables Jumbo Frames.
 TCP/IP configuration: If port trunking is enabled, the port trunking mode will be
reset to "Active Backup (Failover)".
 System port: 8080 (system service port.)
 Security level: Low (Allows all connections.)
 LCD panel password: (blank); this feature is only for NAS models with LCD panels.
 VLAN will be disabled.
 Service binding: All NAS services will be run on all available network interfaces.