User manual

56
Action
Description
Disk Info
Click this button to check details of a disk, including the model, model
number, serial number, capacity, firmware version, ATA version and ATA
standard.
Disk Health
Click this button to check disk S.M.A.R.T information. More details about
S.M.A.R.T information will be provided in the next table.
Scan Now
(under
"Action")
Click this button to scan the disk for bad blocks. If bad blocks are found,
the number of bad blocks will be displayed in the "Status" field. Check
the bad block sectors by clicking on the "bad blocks" message so long as
the disk is not busy.
You can also use this function if a drive is in an error state. In this case,
if no bad blocks found after a complete scan, the error state of drive will
be changed back to normal.
Locate (under
"Action")
Click this button to locate drives using LED lights for easy identification of
physical hard drives.
Set as
Enclosure
Spare (under
"Action")
Click this button to set the chosen hard disk drive as an enclosure spare
drive in RAID 1, RAID 5, RAID 6, or RAID 10. In case a spare drive is
shared by multiple RAID groups, that spare drive will be used to replace
the first failed drive across all RAID groups. Please note that the capacity
of the enclosure spare drive must be equal to or larger than that of the
member drive in a RAID group and this option is only available for an
empty disks. Note that an enclosure spare can only be used within an
enclosure.
Disable Spare
(under
"Action")
Click this button to cancel the chosen hard disk drive as an enclosure
spare drive.
New Volume
(under
"Action")
Click this button to create a new volume. For details, please refer to the
chapter on Volumes.
RAID Group
Click this button and select a RAID group and check its details, including
capacity, RAID group name, RAID type and disk member.
View Mode
(located
above the
system
Switch to list view using the list view icon on top-left of the page. In the
list view, you can show or filter for disks. Set the filter from the drop
down list to only show hard disks based on the device (enclosure or NAS
they belong to), model, type (HDD or SSD), BUS type, capacity, used