User manual

89
4. Enter the target name and alias. Choose to click "CRC/Checksum" to select "Data Digest" and/or
"Header Digest". Then Click "Next".
5. Enter the username and password for "Use CHAP authentication" and/or "Mutual CHAP" and click
"Next". Check "Use CHAP authentication" and only the initiator is authenticated by the iSCSI
target, and users of the initiators are required to enter the username and password specified here
to access the target. Check "Mutual CHAP" for two-way authentication between the iSCSI target
and the initiator. The target authenticates the initiator using the first set of username and
password. The initiator authenticates the target using the "Mutual CHAP" settings.
6. Click "Next".
7. Click "Finish".
8. A new target will be created.
Creating iSCSI LUNs
Follow the steps below to create a LUN for an iSCSI target:
1. Click "Create".
2. Select "iSCSI LUN only" and click "Next".
3. Choose the LUN type and LUN allocation method, enter the name of the LUN and specify the LUN
location (disk volume on the NAS), the capacity and alert threshold for the LUN. Click "Next".
4. Select a target to map and click "Next".
5. Confirm the settings and click "Next".
6. Click "Finish".
7. A LUN will be created and mapped to a target as specified in Step 4.
To create an un-mapped iSCSI LUN, select "Do not map it to a target for now" in Step 4.
The un-mapped LUN will be created and listed under the un-mapped iSCSI LUN list.
The description of each iSCSI target and LUN status is explained in the table below:
Item
Status
Description
iSCSI target
Ready
The iSCSI target is ready but no initiator
has connected to it yet.
Connected
The iSCSI target has been connected by an
initiator.
Disconnected
The iSCSI target has been disconnected.
Offline
The iSCSI target has been deactivated and
cannot be connected by the initiator.
LUN
Enabled
The LUN is active for connection and is
visible to authenticated initiators.