User manual

109
Note that all the data on the selected hard drive will be cleared. Click “OK” to confirm.
When migration is in process, the required time and total drive capacity after migration
are shown in the description field.
The NAS will enter “Read only” mode when migration is in process during 11%–49% to
assure the data of the RAID configuration will be consistent after RAID migration
completes.
After migration completes, the new drive configuration (RAID 5) is shown and the status
is Ready. You can start to use the new drive configuration.
The process may take from hours to tens of hours to finish depending on the hard drive
size. You can connect to the web page of the NAS to check the status later.