User manual

582
Maximum 9 folder pairs can be added.
Options: Click “Options” to set up notification of the backup jobs by email, SMS, or
instant messaging (IM).
Unmount the front USB drive manually: When enabled, users can press the Copy
button for about 8–10 seconds until the USB LED light turns off and remove the front
USB drive from the NAS.
Enable the alarm buzzer:
1. One short beep: Backup has started.
2. Two short beeps: The front USB drive is being unmounted.
Data copy using front USB port
The NAS supports instant data copy backup from the external USB device to the NAS or
the other way round by the front one touch copy button. To use this function, follow
the steps below:
1. Make sure a hard drive is installed and formatted on the NAS. The default shared
folder Qusb/Usb has been created.
2. Turn on the NAS.
3. Configure the behavior of the Copy button on “Backup Station” > “USB One Touch
Copy” page.
4. Connect the USB device, for example, digital camera or flash, to the front USB port
of the NAS.
5. Press the Copy button once. The data will be copied according to your settings on
the NAS.
Note: Incremental backup is used for this feature. After the first time data backup,
the NAS only copies the changed files since the last backup.
Caution: Files are copied from the source to the destination. Extra files on the
destination will be deleted; files of the same names will be overwritten by the
source. Source data will remain unchanged.
As an external storage drive
When an external device is connected to the front USB port, it will be identified as an