User Manual

315
Use the LCD Panel
This feature is only available for NAS models with LCD panels.
You can use the LCD panel to configure system settings and view system information.You can use the
“ENTER” and “SELECT” buttons next to the panel to navigate through the LCD menu.
After starting the NAS, you can see its name and firmware version appear on the panel:
N
A
S
5
F
4
D
E
3
4
.
3
.
0
(
2
0
1
6
0
7
0
3
)
After a few seconds, the panel will be automatically turned off. Then you can begin to configure settings or view
system information.
Viewing system IP address
1. Press“ENTER”or “SELECT”to turn on the panel.
2. Press “SELECT”to browse the NAS model name and the available IP addresses (for each network
interface).
This feature is particularly useful when the NAS is near you.
Viewing and configuring system settings
When the name and firmware version of the NAS appear on the panel, press “ENTER” for two seconds to view the
Main Menu, which will automatically disappearif no further actions are performed in ten seconds.
There are eight options on the Main Menu:
1. TCP/IP
2. Physical disk
3. Volume
4. System
5. Shut down
6. Reboot
7. Password
8. Back