User's Manual

LED Status Description
M.2 Drive Flashes red The data is being accessed and a read/write error occurs
during the process.
Red A drive read/write error occurred.
Flashes green Data is being accessed.
Green The drive is ready.
Off No drive was detected.
M.2 Drive Status Green The drive is ready.
Red A drive read/write error occurred.
Flashes red 5 times per
second
The drive is being located in the operating system.
Off No drive was detected.
2.5 Gigabit
Speed LAN
Green The network connection is operating at 2.5 Gbps.
Orange The network connection is operating at 1 Gbps.
Off • The network connection is operating at 100 Mbps.
• There is no network connection.
2.5 Gigabit
Activity LAN
Orange A network connection has been established.
Flashes orange The device is being accessed from the network.
Off There is no network connection.
USB One Touch
Copy
Flashes blue every 0.5
seconds
• A USB device connected to the front USB port is
detected.
• A USB device connected to the front USB port is being
removed from the device.
• A USB device connected to the front USB port is being
accessed.
Blue A USB device is detected in the front USB port.
Off No USB device is detected.
Audio Alert
Duration Frequency Description
Short beep (0.5 seconds) 1 • The NAS is starting up.
• The NAS is shutting down.
• The NAS is being reset (reset button).
Short beep (0.5 seconds) 3 • The user tried to copy the NAS data to the
external storage device from the front USB port,
but the data cannot be copied.
• The NAS has completed a firmware update.
TS-hx86 User Guide
Basic Operations 53