Owners manual

146
following options are available:
System operations: After enabling this option, the system will beep or announce
system messages (see the below list for available audio messages) when system
operations occur (such as booting and firmware updates).
System events: After enabling this option, the system will beep or announce system
messages (see the below list for available audio messages) when system events
occur (such as system errors or warnings).
Enable speech notification: After enabling this option, beep sounds for certain
events will be replaced by speech (refer to the events list at the end of this
section). You can also choose the audio language and adjust the volume. If this
option is not enabled, the system will only beep when system operations are
executed and system events occur.
The volume control on the Audio Alert page can only adjust the volume for audio
messages, while the volume control on the QTS desktop controls the volume for sounds
other than audio messages. For example, if the volume on the QTS desktop is muted,
and the volume control on the Audio Alert page is adjusted to the maximum volume, you
will still hear audio messages.
Available audio messages:
System boot completed
Shutting down
Updating firmware now, please do not turn off the power
Firmware update completed
Testing system
Running advanced system reset
Running USB one touch copy
USB backup completed
Processing USB ejection
Starting HD Station
Restarting HD Station
Starting Linux Station
Restating Linux Station
You can now safely remove your USB device
Audio test
Note: