User Guide
Table Of Contents
- Table of Contents
- Safety Warnings
- CPU and Memory Specifications
- Power Button and Reset Button Behavior
- USB One Touch Copy
- LED and Alarm Buzzer Specifications
- Beep alarm: All NAS models
- Hot-swap Hard Drives
- Upgrade Memory on QNAP NAS (RAM Module Installation)
- Expansion Card Installation
- RAID Recovery
- Technical Support
- Appendix A: Product Compliance Class
- GNU GENERAL PUBLIC LICENSE
17
Chapter 3. USB One Touch Copy
This feature is only provided by NAS models with a USB One Touch Copy button. Please visit
http://www.qnap.com for more details.
System
Number of seconds (press the one
touch copy button to trigger data
copy)
All NAS models
0.5 sec
Data Copy by the Front USB Port
The NAS supports instant data backup from a USB device to the NAS or the other way round
by using the front one touch copy button. To use this function, follow these steps:
1. Make sure at least one hard drive is installed and formatted on the NAS. The default
network share Qusb or Usb will be created.
2. Turn on the NAS.
3. Configure the behavior of the Copy button in “Backup Station” > “External Backup” >
“USB one touch copy”.
4. Connect the USB storage device to the front USB port of the NAS.
5. Press the Copy button. The USB LED will flash and the data will be copied to or from
the USB device according to the NAS settings.
Note: This feature adopts incremental backup. After the first time backing up data, the
NAS will only copy files that have changed since the last backup.