User Guide
Table Of Contents
- Table of Contents
- Safety Warnings
- CPU and Memory Specifications
- Power Button and Reset Button Behavior
- USB One Touch Copy
- LED and Alarm Buzzer Specifications
- Beep alarm: All NAS models
- Hot-swap Hard Drives
- Upgrade Memory on QNAP NAS (RAM Module Installation)
- Expansion Card Installation
- RAID Recovery
- Technical Support
- Appendix A: Product Compliance Class
- GNU GENERAL PUBLIC LICENSE
26
Chapter 7. Upgrade Memory on QNAP NAS (RAM Module
Installation)
Warning:
The following instructions should only be performed by an authorized and trained
technician.
Strictly adhere to the instructions to install a RAM module on the NAS. Failure to do so
could result in injury to human body or death.
Before starting, please ensure that you turn off the NAS, disconnect the power
adaptor, network cable(s), and also remove any other device/cable that is attached to
the NAS.
Please ensure that you wear an antistatic wrist strap during the entire process to
prevent electrostatic discharge. The crocodile clip should be connected to the ground.
When installing two memory modules, it is recommended to use the same size and
ideally use the same type/model for both slots.
QNAP provides different RAM modules (optional purchase) for users to upgrade the
memory of their NAS.
Follow these steps to install an extra memory module on the NAS.
1. Loosen the screws from the rear to remove the cover (TVS-682 series: 3 screws;
TVS-882 series: 6 screws; TVS-1282 series: 7 screws.)